View All Sea Bird View All Hydrolab Products View All OTT Products View All ADCON Products View All Van Essen Products View All Eijkelkamp Products View All Turner Products View All Turner Products
Products
BP1

This extremely accurate sensor is made in Switzerland for Adcon and employs the same pressure sensor already in use in Adcon's LEV1 water level sensor.

The piezoresitive sensor element is fully temperature compensated and performs with accuracy better than 0,1%FS across the whole range. According to WMO requirements the sensor itself is encapsulated in a robust polycarbonate housing, which will protect the sensor element from erroneous readings caused by wind gusts. A high-capacity Goretex vent makes sure that pressure inside the case equals outside pressure, and that water ingress is prevented.

The sensor box is mounted to the pole of a weather station by means of a mounting bracket and clamp supplied with the product. A shielded 2m cable with a 7-pin Binder jack connects the probe to any RTU of the A723, A733 and A75x product families.

Specs

Pressure range (FS) 500 ... 1500mbar
Sensing element: piezoresistive pressure element
Accuracy: 0.1% FS
Operating temperature: -40°C ... +100°C / -40°F ... +212°F
Compensated temperature range: 0°C ... +80°C / 32°F ... +176°F
Supply Voltage: 3.5V ... 12V DC
Output Signal: 0.1V ... 2.5V
Material: Case: Polycarbonate
Sensor: Stainless Steel 316L (DIN 1.4435)
Dimensions LxWxH:

150 x 80 x 75mm / 5.9 x 3.15 x 2.95 in.
including mounting bracket, goretex vent 
and gland nut

Weight: 330 grams (sensor only) / 0.73 lb.
Protection: IP67
Cable & Connector: 7-pin Binder jack with 2m cable


Documents
Brochure
Related Categories
Water Level Sensors
Telemetry
Soil Moisture