View All Sea Bird View All Hydrolab Products View All OTT Products View All ADCON Products View All Van Essen Products View All Eijkelkamp Products View All Turner Products View All Turner Products
Products
Vento1

This professional instrument was particularly developed to provide a very cost effective, yet WMO compliant wind sensor.

This highly professional pair of sensors is manufactured for Adcon by one of Germany's best known sensor manufacturers. The housings of both sensors are made of robust, seawater resistant aluminium, to withstand even the harshest of conditions.

Wind Speed Sensor

The Wind Speed Sensor has a very low starting threshold of less than 0.4m/s, thanks to its low-friction bearings and its generously dimensioned aluminum cups. The rotating 3-cup unit can be replaced in the field. The sensor will measure speeds of up to 200 km/h.

Wind Direction Sensor

The Wind Vane employs an accurate hall sensor. The vane is also made of aluminum and, like the wind cups, is easily field replaceble.

Both sensors require very little maintenance and will remain within their specifications for many years.

To properly mount the sensors according to WMO requirements the set comprises of an 80cm wide mast mounting arm, complete with mounting brackets. Each cable comes with its own Binder cable plus a separate Y-cable. This allows individual replacement of sensors in case of maintenance or repair, but still occupies only one connector on your Adcon RTU.

Both sensors are also available as individual units. If ordered separately they will be delivered with individual mounting arms and a 2m Binder cable.

Specs

 

 

 

 

 

 

 

 

 
  Wind Speed Wind Direction
Measuring principle: magnetic magnetic
Measuring element: 3-arm cup anemometer, aluminum aluminum wind vane
Measuring range: <0.4 ... 55,56m/s (1.44 ... 200km/h) 0° - 360°
Linearity: < ± 0.5m/s < ± 2.5°
Starting value: < 0.4m/s (1.44 km/h) < 0.4m/s (1.44 km/h)
Output signal 0 ... 2.5V DC 0 ... 2.5V DC
Dead angle: --- 5 ° ± 1°
Switching point: --- North
Case: sea water resistant  aluminum sea water resistant  aluminum
Temperature range: -40°C ... +70°C (non-icing) -40°C ... +70°C (non-icing)
Mounting: Bores with Ø 30mm at max. 10mm wall strength Bores with Ø 30mm at max. 10mm wall strength
Weight: approx. 500g. approx. 500g.
Standards: VDI 3786, sheet 2 / WMO No.8 VDI 3786, sheet 2 / WMO No.8
Cable: Binder Germany, 1m, shielded, PUR Binder Germany, 1m, shielded, PUR
Connector: Binder M9 male 7-pin Binder M9 male 7-pin
 

Documents
Brochure
Related Categories
Precipitation Sensors
Telemetry
Soil Moisture
Data Services